Cyanoacrylate adhesive, General purpose Loctite 401
Description: Loctite 401 is a fast polymerizing, single component cyanoacrylate adhesive with low viscosity. Designed for materials that are difficult to bonding. Surface moisture to a lesser degree affects the curing rate than other standard CA grades.
- Color: transparent
- Chemical type: base - cyanoacrylate
- Consistency: liquid
- Temperature range: -40°C ~ +80°C
- Setting time: 3 ~ 10 sec
- Viscosity: 100 MPa · S
- Net Weight: 20g
- Quality: Factory Guarantor
- Large wholesale - discount is not indicated. It is discussed in detail on request. Specify
Описание
The scope of Loctite 401:
Rapid bonding of a wide range of materials: metals, plastics, elastomers. Good gluing porous materials or adsorbents, as for example, wood, paper, leather or fabric.
Consumption of glue Loctite 401:
One drop of adhesive covers (compression of the two glued surfaces) a circle with a diameter of about 2.5 cm, One gram of glue contains 25-35 freely falling drops.
Instruction manual Loctite 401:
- Clean bonding surfaces with Loctite 7063 cleaner.
- Apply adhesive sparingly to one surface.
- Best bonding results are achieved at room temperature
- Excess glue will prolong the time of curing and affects the adhesion strength.
- Connect the glued surface and fix for 5 – 10 seconds.
- Final bond strength is achieved within 24 hours.
Precautions:
- Sleepaway fingers, rinse with warm water.
- After some time, fat Sam will reject the glue.
- In case of contact with eyes, rinse immediately with plenty of water and seek medical advice.
Комментарии 0
Комментарии отсутствуют
Чтобы оставить комментарий нужно авторизоваться!
Отзывы 0
Чтобы оcтавить отзыв и голосовать необходимо авторизоваться.
Отзывов для данного товара пока нет.
Файлы
Новости
26.03.2026 Для чего применяются порошковые красители?
Порошковая краска для линз очков — это материал, позволяющий изменять цвет и степень затемнения оптических линз. Она используется для защиты ..
18.02.2026 Запущено производство рецептурных линз
Мы запустили услугу производства рецептурных линз по сложным рецептам — включая астигматические, прогрессивные, бифокальные и другие ..
01.02.2026 Материал β‑Ultem для оправ очков
β‑Ultem — это разновидность технологичного термопластичного полимера (полиэфиримид, PEI), используемого для оправ очков. Он отличается ..
